Made4Trade End Feed Bent Tap Connector 22mm x 3/4" (2 Pack)

3 GBP

End feed capillary fitting is part of the Made4trade range and manufactured to BS EN 1254-1. This fitting joints copper tube manufactured to BS EN 1057 using solder. It is suitable for above ground hot and cold domestic or potable water services, central heating systems, low-pressure steam heating and pressurised unvented heating systems. It is equally suitable for sanitation services and compressed air lines, gas distribution systems for natural and manufactured gases. A solder joint is created through the principal of capillary action, when the fitting and tube is assembled and heated to the appropriate temperature, solder becomes molten and is drawn into the gap between tube and fitting for a durably reliable joint. It is recommended soldering flux is also used to aid in this. Plumbing Solder available (code 11150). Plumbing Flux available (code 73706) & (code 21961) * Manufactured from copper * For use on hot and cold water systems * Neat, tidy installation when installed by an experienced fitter * System covers all aspects of gas and heating systems in domestic and light commercial applications * WRAS approved * Manufactured to BS EN 1254-1 * Min temperature at Max pressure: 30degC at 25 Bar * Max temperature at Max pressure: 110degC at 10 Bar * 25 Years Guarantee * Requires solder and blowtorch | Made4Trade End Feed Bent Tap Connector 22mm x 3/4" (2 Pack)

Buy